How do I upgrade the software on my MOTONAV TN20/TN30?
To upgrade the software:
-
Power down the MOTONAV by holding down the power button for at least 8 seconds
-
Insert the correct SD card into the SD card slot of the appropriate unit.
-
-
SYN3049A - TN20
-
SYN3050A - TN30
-
-
Power on the MOTONAV by pressing the power button.
This hould start the upgrade automatically. -
Once the upgrade is complete, the MOTONAV will transition to the MAP screen.
-
Power down the MOTONAV again, by holding down the power button for at least 8 seconds.
-
Remove the SD card from the card slot.
-
The MOTONAV is now upgraded and ready to use.
Note: It is recommended that the MOTONAV be fully charged or connected to the charger to ensure power is not lost during the upgrade process. The upgrade process will take approximately 3 miutes.
Was this information helpful?
Your feedback helps to improve this site.